PRINCESS PEACH-INSPIRED CROWN 3D PRINTED - ETSY ESPAÑA EN ESPAÑA

(Please Note: Dates given by etsy are an estimate only. If you need a prop by a certain date then let us know by message before ordering or when placing an order and we can try and help ^_^) It's hard ruling the Mushroom Kingdom. Toads squabbling over politics. The incessant incursion of Goombas and Koopa Troopas. Nevermind the constant risk of being kidnapped by his spikiness himself. But its not all bad. At least the crown is cool, right? And you don't have to see that crazy from Sasara land too often... Well, not all of us can be mushroom kingdom royalty (we tried a coup once, but finding it was hard and we just got lost in a sewer) So instead we bring you the next best thing, a 3D Printed Princess Peach-inspired crown for Cosplay or decorative use - which we make to order. This has been custom designed using official Nintendo art as a reference. This crown is actually version 2 - our original version wasn't quite as fancy and didn't have the band running around the middle! It is printed in durable plastic, and incorporates thin bands strung across the inside to allow for hair grips (to attach to natural hair) or safety pins (to attach to wigs, etc) It's 9.5cm in Diameter, and approximately 6cm high - about the same as a thick roll of parcel tape. Please note the jewels are modelled into this crown. This item is printed to order. Please note that this is a 3D printed item and so has a unique texture. If you have any queries about this, please contact us before purchase!and